1000M fiber media converter:FMC-1000
1000M fiber media converter,
giga fiber to ethernet converter,
1000M ethernet over fiber converter
1000M fiber media converter,fiber to ethernet converter:FMC-1000
The fiber to ethernet converter transform the transmission media of Ethernet signal from CAT5 to optical fiber. it can extend the transmission distance to several kilometer or hundred kilometer.
Using media converter is a economical solution to achieve long distance transmission base on current status.
This product supports IEEE802.3z 1000Base-Tx/Fx protocol, as well as full duplex and half duplex mode. This manual is for 1000M transceivers.
The transmission media adopts CAT5 twisted-pair with typical length of 1000 meter. It features the function of automatically identifying the through line and cross wire
SC/ST fiber interface is of duplex mode type, including two interfaces, namely TX and RX. When the two sets of optical transceiver are interfaced or connected to switch with fiber interface, the fiber is in cross connection, namely “TX-RX”, “RX-TX” (direct butting for single optical fiber).
The network device (work station, hub or switch) with RJ-45 interface is connected to RJ-45 jack of optical transceiver through twisted-pair. And the multi/single mode fiber is connected to SC/ST fiber interface of the optical transceiver. Then switch on. The corresponding LED is on for correct connection. (See the table below for the LED indicator lamp)
1. Standard Protocol: IEEE 802.3z 1000Base-TX/FX standard
3. Operation mode: full duplex mode or half duplex mode
4. Power supply parameter:
outside: 5V DC 2A
built-in: 110-265V AC 48VDC
5. Environmental temperature:<60.Relative humidity: 5%-90%
8. TP cable: Cat5 UTP cable
9. Transfer fiber:
multi-mode: 50/125, 62.5/125 or 100/140μm
single mode:: 8.3/125, 8.7/125, 9/125 or 10/125μm
Upper limb rehabilitation
Lower limb rehabilitation
Whole body rehabilitation
Treatment table series
Lumbar and neck traction bed