G.SHDSL modem is E1 or V.35 ethernet transfer over 2 wire copper line modem
GSDSL is FPGA-based 2-wire 2304Kbps modem. According with ITU G.SHDSL standard, with best concocting technology and very good frequency spectrum compatibility, It has 3.5km-9.7km transmission distance in special lines with 24AWG(0.5mm) and 26 AWG(0.4mm). It can be used in every high quality and high-speed telecom operation such as transmitting voice, data and images. It also supports N * 64Kbps rate (N=1~32) of interface of V.35 and E1(G.703). GSDSL has strong supervisory control function. You can learn the start-up, running and line malfunctioning and other functions from the panel. In case there is something wrong with the system, one can locate the fault conveniently with loop back test to administrate networks.
Not only with low operating cost, but it is also easy to operate, install and link. One can use the dial switch on the back panel to setup work mode and transmission rate while slave modem can automatically follow master modem rate (that is the rate switch of the slave dosen’t work). So you can administrate the remote equipments in networks. There are many indicator LEDs on the panel to display work status and line of equipment
PCM multiplexer
TDM over IP
G.SHDSL modem
E3 DS3 to ethernet converter
fiber optical modem
fiber to ethernet converter
Ethernet HDSL Modem,Ethernet over 2-Wire G.SHDSL modem:HDSL
Ethernet HDSL Modem
Ethernet bridge
V.24 Modem V.24 over 2-Wire G.SHDSL modem:GSDSL
V.24 Modem
V.24 transfer through copper lines with 24AWG(0.5mm) and 26 AWG(0.4mm)
V.35 G.SHDSL Modem V.35 over 2-Wire modem:GSDSL
V.35 G.SHDSL Modem
V.35 transfer through copper lines with 24AWG(0.5mm) and 26 AWG(0.4mm)
E1 G.SHDSL Modem E1 over 2-Wire modem:GSDSL
E1 G.SHDSL Modem
E1 transfer through copper lines with 24AWG(0.5mm) and 26 AWG(0.4mm)