Ethernet HDSL Modem,Ethernet over 2-Wire G.SHDSL modem:HDSL

Ethernet HDSL Modem,Ethernet over 2-Wire G.SHDSL modem:HDSL

Ethernet HDSL  Modem

Ethernet bridge

  • Description
  • Inquiry

Ethernet HDSL Modem,Ethernet over 2-Wire G.SHDSL modem:HDSL

Description

HDSL is ASIC-based 2-wire 2.3Mbps Ethernet bridge SDSL modem. It uses SDSL(multi-rates digital end-user line) technology so that the data rate between two joint LANs can reach 2320 Kbps, the distance can be reached 3.29km in 24AWG(0.5mm) communication line and 2.51km in 26AWG(0.4mm) communication line. The modem can connect two LANs through a pair of twisted-pair to extend distance of LANs. With low cost, simple operation, and convenient use, it is suitable for cost-sensitive bridge connection or in LAN as stretcher or subsection. Ethernet conforms to standards of IEE802.3u and IEE802.3 and its speed rate is 10/100BaseT self-adaptive.

It can be installed and connected conveniently. One can use the dial switch on rear panel to setup work mode and transmitting speed rate, then connect cable to put it in use. There are many indicators on the front panel to display work states and line status of equipment.
HDSL is a high-performance self-educated long-range Ethernet bridge. It can receive frame in MAC net-bridge of LAN and carry out transparent transmission of MAC addresses. It can store a maximum of 1024 MAC subnet address. HDSL can learn automatically MAC address in the connected LAN and only transmit the target address to frame in another LAN.

 

Features

LAN Feature:

Standard:Conform with IEE802.3/Ethernet
Work mode:full duplex/ half duplex
Data rate:10/100Mbps;self-adaptively
Physical interface:10 /100BaseT(UTP); shielded RJ-45

 

Ethernet Features

LAN  Table:1024, learning automatically and
refreshing automatically

 

WAN(E1/G.703)Features

Data rate:256kbps; 384kbps; 1024kbps
1280kbps; 1536kbps
2048kbps; 2320kbps
Transmission mode:Synchronous full duplex; HDLC
Line interface:impedance 135ohm, physical
interface RJ45, with pin 4 and pin
 5 (middle 2 lines)
Power supply:220V±10%,50Hz;48VDC(optional)
Power consumption:5W;
Volume:225mm*145mm*40mm;
9”L*5.8”W*1.6”H

 

Transmission distance and rate

The following table display the rata speed rate and the maximum distance supported by HDSL  in 24 AWG(0.5mm) & 26(0.4mm) AWG communication lines. It’s actually transmission distance lies on line distance, net bridge connection and line noise, etc.

 

 

 

40G module
QSFP+ LR4
QSFP+ transceiver

100G transceiver
QSFP28 SR4 transceiver
QSFP28 LR4 transceiver
CFP transceiver
CFP2 transceiver
CFP4 transceiver

PDH Multiplexer
SDH Multiplexer
E1 Converter
TDM over IP
Modem
PCM Multiplexer
Fiber Media Converter
Fiber Video Converter
SFP fiber module

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 
Ultra Low Temperature Freezer
Speed Reducer
Rehabilitation Equipment
Fiber Optical Multiplexer






Online Service
Live Chat